Thanks for responding.

1) Okay so when I installed the engine I had put a new crankshaft position pigtail in her. I just coppied the orignal connector, but I was wondering if the previous owner messed with the wires on the original. That's why I was inquiring about what terminal is what. I wired to what the Haynes manual said. I wonder if the wires where messed up would it mess up the new crank sensor?

2) So basically I checked all grounds for ecu, every ground is good. I guess I will inspect the wires from crank to ecu to asd to coil?

3) Idk if this helps but I disconnected the crank sensor and I still had 8.3 volts coming out of signal to crank.