Alright it worked before I took it out as far as I know "a bearing within the trany is bad" I just ended up purchasing another used one but, this did work when it was pulled just it made a "grinding" noise when the clutch was disengaged in nuetral, 1st, and 2nd. Selling as is and not looking to tear it apart anymore than it already is.
As you can see its torn a part a bit with some surface rust. I think someone out there could use it for just the bellhousing or if they know what they are really doing with the tranny fix it.
150 obo + exact shipping, would rather do pick up. I'm located in Jacksonville, FL I'd trade it for just ONE of the rims pictured below its off a 2000 Galant and I have a set of 3 can't find any anywhere around here.
97' Mitsubishi Eclipse RS ... AEM CAI, Headers, Test Pipe, 2.5" Mandrel Bent Exhaust, MSD Coil, MSD Super Conductor Wires, NGK plugs, B&M short shifter.
#91109, "RE: FS : NV-T350 5spd" In response to Reply # 1
150.00 shipped is my offer sir. If the trans was grinding and its one of the shaft bearings then its not worth fixing. I could use the cases though and some of the gears.
Search
Printer-friendly copy
1 User in Chat
