|
okay it has come a time were as im am seriously considering parting with this car, id much much not rather part the car out, unless all of it could be parted at one point. the only problem known with the car at this point, is the car isnt getting any fire (power) to the coil pack, could be ecu, could be a short in wiring somewere, im just pretty much tired of working on it. but here we go
Exterior:
10 peice kaminari widebody kit 2003 eclipse fuel door trd supra widebody wing, modified to fit the trunk targa top conversion fiberglass roof proto type hood- i gurantee you will never see this hood again, or on your coast apc black projection headlights clear corners- 2 sets to go with the car full west coast house of kolors lilac marble and black silver marble, with a rolling tearing of metal effect airbrusehed.
Interior:
near stock,
painted interior peices, black- silver accents 10 point scheulde 40 piped roll carge has the side impact and chasis drop out bars to go beside the door the cage travels down throudh to dash also the roll cage has custom laser cut gussets through out it. also has a nitrous bottle rack in the rear, and halo bar around the roof. stock seats with 5 point harness cut shifter black carpet
rollers:
have ss brake lines- not installed painted silver calipers 19inch kmc suicide wheels- these wheels retail for well over 1600 alone without tires, reseaoned because they probaly are the lightest 19inch wheel thats was on the market( these wheels are no longer availiable) they only 19lbs a peice. brand new toyo proxies tires - 225/35/19 new factory struts sprint drag springs
electronics and guages:
Apexi AVCR boost controller Apexi SAFC fuel controller Apexi RSM controller Autometer boost Autometer EGT Autometer A/f Autometer Fuel pressure Autometer water temp Autometer Oil pressure Autometer triple pillar Autometer instrument cluster guage bezel
Engine:
the engine was professionally built by bob stockum.
2.4 block
0 mile crank meiling pump clevite bearing set t-2 rods j.e pistons custom baffles block has blueprints and has been balanced arp everything head work was done and flowbenched by bobstockum 2.0 5 angle valve job, mostly hand done crane 1mm ob exhaust valves crane intake valves crane hardened washers crane springs crane number 16 cams pt lifters pt rockers arp studs new magnet new sensor hella king port and polish job has a aftermarket headgasket, just cant think of which one right now HRC exhaust manny HRC fresh s20g turbo Custom 2.5inch ic pipe Turbo xs RFL Bov Huge fmic Msd inline fp Walbro Intake fp Vortech SFMU Nitrous Express wet kti 35, 55, 75 shots all SS fuel lines Lots of AN fittings new clutch slave cylinder
new front windshield and new rear glass.
pics:





keep in mind this car has never seen the street since its been reworked and 90% of this stuff is new. my asking price for the car is 12,500 usd, i will entertain trades for sure, also wouldnt mind trading for a nicely worked turbo 2gnt or 4g63 and cash. if this price is too high u think, go suck a dick, if you only knew how much money im losing on this car for letting go for 12,500. thanks for lookinng and let me know
DWAYNE H 1996 eclipse under construction widebody eclipse, targa top, 19inch rollers, big brakes, 10 point custom cage, frank 2.4 hrc s20g turbo, custom marble paint job
 2000 Yamaha R-1, 165rwhp 117 ftlbs tq
 ALMOST THERE...... MUWHAHAHAHAHAHA
Originally posted by etx(SIUECLIPSE) Yeah right. He is making 380fwhp with ebay hoses and the HRC 2.25" clamp on downpipe attached to his stock exhaust. And a SFMU, LOL! You should be maimed and beaten you fucking liar.
|