I'm selling my 420a block again. I just tried selling it, then got some money, now I have found a 92 240sx with a sr20det from a friend for $300. I couldn't pass up the offer so I am selling the block again.
It has 8.8:1 JE pistons, total seal rings, eagle forged Long rods, clevite 77 bearings, blanced and blue printed, arp main studs and a melling oil pump.
Also a head casting with the stock springs, retainers and valves still in it. I have a new set of Ti springs and retainers from modern performance for it but not installed. I have all stock parts for the engine, including cam shafts, cam gears, timing belt tensionor, lifters and rockers, and all the hardware and accersory brackets and more. I also have a polished valve cover for it. I have an intake manifold that I have been porting myself, it's half way done. I don't have any pictures right now of it though. I will have some in a few days. Looking to get 2K for everything.
#52404, "RE: FS: Built 420a block" In response to Reply # 1
apparently not.
Having Problems? Heres my Three step solution to anything 2gnt related. Step 1: Put down everything in your hands. Step 2: Grab a lucky strike, Smoke it. Step 3: Walk to the fridge, double fist some keystone ice, sit down in the shade, drink one beer, finish cigarette, drink other beer, roll a joint, smoke it, walk back to your problem, and in about 5 minutes the solution will come to you. If not. Go here: here
If still nothing, your trying to hard. Start over at step 1.
#52457, "RE: FS: Built 420a block" In response to Reply # 2
I live in MD. I don't have any paper's. All the machine work was done in a shop. I just bolted it all together. All the studs were pretorqued and streched in the shop. It was bored .020 and they machine honed the crank journals.
#52465, "RE: FS: Built 420a block" In response to Reply # 3
I checked with the machine shop about the papers. They said they checked the balance on it, and it was close enough that they didn't need to do anything. He said technically it was just balanced, not blueprinted becuase they didn't write the stuff down.
#52480, "RE: FS: Built 420a block" In response to Reply # 6
The shop is not a automotive shop, they are a machine shop. They do not have the equipment to remove engines. They just do work on the blocks such as cleaning, boring, decking and honing.
#52503, "RE: FS: Built 420a block" In response to Reply # 8
The shop is called crankshaft grinding and machine in Millersville. But like I said, they wont install or anything. They wont garuntee anything because no one garuntees a race motor. Thats why japanese motors only come with startup warranty's. If you go out and run 30 psi on it in the first 15 miles, it will burn up, thats given. So they will not garuntee anything.
Search
Printer-friendly copy
1 User in Chat
