#5452, "Megasquirt load vs map sensor" Jan-01-12 12:14 PM by SilvrEclips
Running MS 1 v2.2 with the 11c1 code.
Recently my 4 bar map sensor was having issues, it worked fine but all of a sudden the load % was about 20 below the map sensor kpa. These values have always been pretty close at atmospheric pressure. So thinking my map sensor was bad I put in the stock 2.5bar sensor and the map was reading 99kpa and load was 100%. Everything looking normal now I ran this setup for a few months till I needed to upgrade the sensor again. Bought a new 3 bar sensor and put it in. Same issue as before now. map is reading 99kpa and load is reading 81%.
The map sensor works fine so is this normal? I shouldn't have to rescale all of my maps from just changing the map sensor.
EDIT: Yes I changed the sensor to 300kps in megatune and the configure mode.