#12206, "RE: Monitor in Pass. Airbag?" In response to In response to 0
i had a 7 in mounted in there but it was a custom pita! i mounted it and later found out the angle was no good it had to be tilted more towards the ground to be able to see the monitor correctly so i had to build up a foundation for it to sit in to hold the monitor upright a little more. i used a variety of stuff to include bondo and liquid nails. this was all before i knew anything about fiberglass which would have been alot easier. i started by removing the air bag module with a dremel tool. Warning if the air bag goes off while you are working on it you mostlikely will die so be careful. ill post a pic of the end result for you to get an idea, if i did it over again i would have glassed it. also only the passanger will be able to view this monitor the way i did it. driver can see but its kinda dark cause your viewing from an angle.
Ps. my interior is not as blue anymore ive maade some changes
98 RS: Mods: Custom Stage 2 Turbo kit , 55mm throttle body, gutted cat, evo cat back exhaust, p/p intake manifold,p/p Head, af-x underdrive pulley, B&M short throw shifter,Built bottom end Je pistons eagle rods 8.8:1 compression.
Status:Up and running again! nice new paint
Custom stage 2 hahn turbo kit Hahn Super 16g turbo (ceramic coated) Hahn manifold (ceramic coated) Hahn Downpipe assembly Hahn intercooler piping smic Hahn oil line kit Type s bov 2G Gsx smic walbro 255 fuel pump Synapse missing link Vortech s-fmu NGK Bkr7e11 Plugs A-pillar w/boost, a/f, oil pressure gauges