i had a 7 in mounted in there but it was a custom pita! i mounted it and later found out the angle was no good it had to be tilted more towards the ground to be able to see the monitor correctly so i had to build up a foundation for it to sit in to hold the monitor upright a little more. i used a variety of stuff to include bondo and liquid nails. this was all before i knew anything about fiberglass which would have been alot easier. i started by removing the air bag module with a dremel tool. Warning if the air bag goes off while you are working on it you mostlikely will die so be careful. ill post a pic of the end result for you to get an idea, if i did it over again i would have glassed it. also only the passanger will be able to view this monitor the way i did it. driver can see but its kinda dark cause your viewing from an angle.




Ps. my interior is not as blue anymore ive maade some changes