I just recently bought a shortblock from a member and one of the transmision mounts on the bed plate was broken off. So now i need a new one or advise on fixing it. I can't find the peice that's broken off either.
Thanks

what year is your car i have one off a 95 so let me know and say 65 shipped

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on

As a heads up, you will need a line-bore if you put on a bedplate from another block. The main bearing journals will not be lined up right..They may "look" ok, but trust me, they wont be. Each bedplate is line bored at the factory to match each block, much like the cylinder head cam bearing caps.

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)

XtremeRS is right. Also, It's more expensive to buy a new bedplate, line-bore the assembly, and order custom bearings than it is to just throw away the broken block and buy another one with a bedplate already included.

If the "transmission mount" you're talking about is just one of the dowels, those are cheap and you can search 2gnt for the part number. If the actual bedplate cracked/broke apart then it's junk.

With the pertinant oinfo posted by Matt and Dan, I will lock this for not following the rules.