Well, I have decided I am going to go to a full stand alone...It's time for me to make that jump...so the Port Fueler is going up for sale.

I had enough fuel to run ~ 12.2:1 AF up to rev limiter @ 16psi on my S20G (TDO6H-20G/TDO6-8cm^2), on pump gas. I didn't really mess with the HAHN pre-programmed maps much.

With some tuning, I think 17-18psi would be possible on pump gas. Oh yeah, and tire spin from 65-90mph ROCKS!

Included:
-4 x Accel 415cc Injectors
-1 x HRC Port Fueler Module & Injector Harness Adapter
-1 x Tach Adapter
-1 x HRC Injector Plate
-1 x Fuel Rail, SS Braided Line & Mounting hardware
-1 x SplitSec Software

Notes:
-I ported the plate out slightly to better match the ports on my head. But there was not much material taken out. I will try and get pictures in the near future.
-I have used everything for less than 6 months, and I was the second owner
-Only thing you would have to source yourself is a 1:1 FPR, since I will be retaining the use of the Aeromotive FPR that came with the kit.
-This is for the Neon 420A, BUT I am about 95% sure it works on the Eclipse 420A. The plate is the original design, which is a 2-piece plate. One for the ports to the head, and 1 small plate for the coolant passage. I think this was made so that it could be used on either the Eclipse or Neon. Though I will try and get confirmation on that.

$650 shipped

I don't know many people on this board, but just about everyone on neons.org knows me. So if you need references, I could probably find some.

Post here or Email me @ TurboNeonRT@comcast.net...

Thanks,

Sean