Hey guys,
One of my tail lamp cables went bad and now one of the center bulbs will not work properly (i know its not the bulbs, bulbs work fine if i switch them to the other lamp). This is the cable that holds the 2 center bulbs in the tail lamp. I tried going to Satan to see if they sold it by itself but they tell me it only comes with the whole tailight assembly. I'm not about to spend on a new tail lamp for the little cable holding the damn bulbs that's probably a few bucks only. Anyone has an extra they're willing to part with?
Thanks

Louis

post a pic of what exactly you need and I'll get you one off my parts car.

**********************************
Current Mods:
AEM V2 intake, MP 60mm TB, Accel 24lb injectors, Crane #12 cams,Ross forged 10:1 pistons, Eagle H-beam rods, ARP head and main studs,
Ported and polished head, Crane valve springs, PT rockers and lifters, MSD coil, Accel wires, AFX underdrive pulley,
DC sports ceramic coated header, Ebay testpipe, Apex-i N1 catback, 255 lph fuel pump, Apex-i SAFC, Spec Stage III clutch, Phantom Grip,
full Energy Suspension polyurethane bushing kit, Tokico springs and blue shocks, Russell steel braided clutch and brake lines,
17" Koning Imagines, NOS 100 hp direct port N20 kit

Here it is..
I dont really need the bulbs, they work fine, is the actual cable thats bad in my car.



Louis

yea rewire it yourself...so much easier. Plus its called Wire!...cable is underground equipment, above ground is wire.

Terry

Hey buy these tails off me for 15 + 6 for shipping and use what you need. The drivers side has a spider web crack on the top but the other one is good. Just an offer.

http://www.murderpimp.com





2gnt T-shirts&swag
http://www.cafepress.com/mads

if you look in federal electrical code it is the design of the wire/cable. cable is designed for underground due to jacketing and heat characteristics. CATV wire is called wire ask any cable tech.

I may have the wires you need if you dont want to fix yours

...what about ethernet cable..isn't really made to go underground.... but anyways.....I thought about rewiring but how am I going to open the bulb casings without breaking the plastic part..they have no tabs or screws form what I can see...and I know its something loose or not making good contact there cos when I move it around it works ok but then goes back to not working. My tailights are in great shape so I really need only the "wire" but I understand its going to be kinda hard for someone to sell just the cable..err..wire. I'm going to give it a few days to see if i can get the wire only....if not I just might take you guys up on the whole lamp assembly.

No, don't know how to solder...but from what I can tell the issue is inside the bulb casing (if I move it around it works for a while but as soon as i put it back on it goes back to acting up) so can't really solder there without breaking the casing first . Anyone has one lying around?....its becoming annoying having one extra-fast turn signal with a bulb out and one normal. Maybe someone has an old/non working tailight willing to sell as long as the cable's there..I'd just hate to buy a whole new working tailight when all I need is the wire....