Still for sale 50.00 plus shipping...

Already been turned and only driven 50 miles. I am selling it because I like to waste money and bought a Clutch Masters aluminum flywheel.

Perfect shape and ready for install

Let me know

williams_brian_99@yahoo.com

Will this mate directly to my 96 Avenger block? I"m assuming it will. I want to change from a modular to non-modular design for easier upgrades. $50? I may take it, the only problem is I don't get paid till March 7th (new job). Can you wait till then? I also need to get a Stage 2 or higher clutch. Any places that I can get it cheap and/or got a deal for me?

Jeremy

96 Indy Red Dodge Avenger I4 5spd
225.7whp/227.2wtq @ 10psi, currently running 12-14psi.
HRC Stage III turbo setup
JE 8.8:1 pistons
Eagle rods
block bored .020" over
GReddy FMIC w/ custom piping
1G crushed BOV
SPEC Stage 3 clutch
2.5" DP, 2.5" high flow cat, 3" ERT catback w/ Magnaflow muffler and 3" tip.
much much more...

the flywheel will bolt right up to your car no problem,

hit me up for the clutch ive got a group buy going on at the moment any style clutch u want

Bill
Got Tude Designs

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

I always thought clutches were more expensive for modular than for non-modular. Is it jsut the opposite? If that's the case, I'lljsut stick with my modular and upgrade the clutch! Whichever's the easiest/most inexpensive way to do this, I'm gonna go that route. Any suggestions?

Jeremy

96 Indy Red Dodge Avenger I4 5spd
225.7whp/227.2wtq @ 10psi, currently running 12-14psi.
HRC Stage III turbo setup
JE 8.8:1 pistons
Eagle rods
block bored .020" over
GReddy FMIC w/ custom piping
1G crushed BOV
SPEC Stage 3 clutch
2.5" DP, 2.5" high flow cat, 3" ERT catback w/ Magnaflow muffler and 3" tip.
much much more...

if it is still for sale, justone, will you do $50 shipped?
lemme know... and how much did you get the CM alum flywheel for, if you dont mind me asking?

non modular is more expensive

^^what once was^^


^^what is now.. and permanently^^

CVedEclipse:

Still for sale...ready to go out whenever.

Let me know -- williams_brian_99@yahoo.com

I payed 420.00 shipped for the CM flywheel.

I'll take the flywheel for $50 + Shipping.... shipping will be to zip 16841.

Lee.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Megasquirt powered 420A
Custom turbo system

http://www.ms-custom.com