I have low compression on one of my cylinders, blown rings or lands, and am gonna replace it with a stock one till I have enough for the rebuild. I need a good condition stock piston/ ring and perferable rod attached. Thanks
Alvin

http://www.cardomain.com/id/96rst

I have a used built shortblock for sale. I bought the block from Armond planning to boost my car, but i've changed my mind. Email me if your interested, and i'll give you my asking price.

"I am selling my built shortblock from my car (www.armond30.com/adp/001.html). the block comes equipped with oil pump, oil pickup, knife edged nitride treated crankshaft, ARP beadplate studs, Clevite77 main and rod bearings, Crower rods, JE pistons with Hastings piston rings with a ring gap of .015 top and .021 middle. Piston compression is 8.8:1. seals and oil pump have about less than 8K miles on them. holds perfect compression (185 across the board with crane #18 cams). balanced to spin up to whatever rpm.......seriously.the block is bored .040 over. block is already broken in. bolt up and boost/juice away. comes with oil pan with oil return drain for turbo." - Armond

95 GST | So-Cal

how much u askin 4 the shortblock bud?

Dave-


The Darkness!

Bump....need ASAP
Alvin

http://www.cardomain.com/id/96rst

I have a stock piston / rod assembly in used but good condition. 60k miles on them. It will have rings but you don't want to re-use old rings. Go buy a new ring set and new rod bearings to go with this.

Also, make sure your crank has never been machined, and your cylinders have never been bored. I am selling a stock, standard size, standard bore piston.

$30 shipped, PM me for my paypal address.

i have four stock rods/pistons with rings and wrist pins. the rings and pins only have abotu 2k on them when i re-ringed them when i myke'd the block. if ^^^ doesnt sell them to ya. i sell ya all four for $35 shipped. all have 31k on them except the fairly new rings/pins. i would re-ring them again though for proper seating, but you maybe able to get away with these since they are still fairly new. no gurantee on that though bro.
LMK

Mike

I can give u a great price on 4 pistons rods etc BRAND NEW and inexpensive

Dave
SpooledupRacing@comcast.net

Dave
SpooledupRacing@comcast.net
Spooled Up Racing ®
86' 13B 5spd, N/T
Rotary Power FTW!