this motor will be up for grabs if someone is willing to give me my asking price, which is about 5-600 less than what i paid.

the specs is as follows

fully built and blueprinted from the bottom up

meiling oil pump

clevite bearings

3000 mile 2.4 crank

T-2 rods~ treated

wesico pistons

total seal rings

ported and polished head by bob stockum

5 angle race grind valve job

crane valve springs

crane retainers

pt rockers

pt lifters

1mm oversized manley valves

arp head studs and hardened washers kit

crane # 16s cams

fidanza cam gears

all new factory gaskets

oil ports have been opened up for better lubrication

head was flowbenched

balance shafts removed

bottomed was balanced.

this motor has been built to hold 30 psi's and make over 475 hp. with just turbo no nitrous. this is pretty much a bulletproof setup with the right fuel. its been balanced to spin 9000 rpms and make extream amount of horsepower with the right turbo setup. its pretty much turnkey.

the asking price is 4500 firm.



DWAYNE H
1996 eclipse
under construction widebody eclipse, targa top, 19inch rollers, big brakes, 10 point custom cage, frank 2.4 hrc s20g turbo, custom marble paint job

2000 Yamaha R-1, 165rwhp 117 ftlbs tq

Why are you selling it. Don't u need the motor to get your car running again or did u change to a different setup.

i have a srt in mine, i think i might go with a basic 2.0 setup(built of course). im still contenplating, if someone doesnt give me what i need out of it by the year is up, its going in the car.

DWAYNE H
1996 eclipse
under construction widebody eclipse, targa top, 19inch rollers, big brakes, 10 point custom cage, frank 2.4 hrc s20g turbo, custom marble paint job

2000 Yamaha R-1, 165rwhp 117 ftlbs tq