I am looking to purchase the entire motor (top and bottom). Would prefer someone within 100-200 miles of northern Ohio so I can pick it up but willing to talk with anyone. Let me know. Thanks

99GSX Auto 14b@17psi 13.345@102mph

bump

99GSX Auto 14b@17psi 13.345@102mph

You've got mail!

_____________________________________
Jason ESi-T

04' BMW 325Ci
91' Nissan 240SX
98' Eagle Talon ESi (sold)

I've got a complete one but it has wrist pin wrap...let me know

I have a complete working stock head for sale, and lots of bottom end brackets and accessories. $250 shipped for everything.

if you could wait about 2 months ill have one. and i live between cincinnati and dayton. so not too far away.

"Shop smart, shop S-Mart!" ~ Ash
Member # 1523

I have head, block, bedplate, oilpan.... no rods/pistons/crankshaft unless you want the them w/ it too, but the crank needs to be turned and they cant machine our rods b/c they are break-a-ways.. but let me know, I live in South West Virginia (swva).. email me or aim me..... aim..... rawdawgstv...email...ibplaynuall@hotmail.com

~STV~

cant machine the rods hrm thats a new one...

Bill

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

I have a block with bad rings in one cyl with je pistons and eagle rods bored 20 over already. I live in metro detroit, we could meet up if you want it. I was planning on selling the block as a core and the pistons and rods seperately on ebay. If you want it IM me at spinalazusa or shoot me an email.

I also have a head with stock cams, new rockers and lifters, stock cams and stainless valves 1mm+ if you want that...

____________________________________________________
four nails four corners four riders and four horses

I'm talkin bout machining our rods where the bearings are.. when I spun my bearing, I took my rods to 3 different machine shops and all three said it was impossible, b/c how they break our rods instead of cut and torque down... ya know how are rods will only line up one way w/ its own mating cup? that's what I'm talkin bout..

~STV~