Well...I hit a monster pothole this evening that I could not avoid due to on-coming traffic. When I hit the pothole it jarred my entire car badly. I heard a noise like something hitting the ground and sliding, but didn't think a lot about it at the time as I was in a hurry to get to my parents house for a dinner party. I got home and went to get ready. When I got back out in my garage to leave, I noticed that my passenger side (Avenger) Carbon Fiber GSX door piece was MIA. It looks like some of the clips finally failed and the piece flew off.

An hour or so had already passed, so by the time I went back to where I had lost the door piece, there was no trace of it. I figured if I had found it, it would have been run over or something. But there wasn't a trace of it anywhere. I looked up and down the entire block in everyones yards and all around. I knocked on every door down that entire block. No one had seen or picked it up. The worst part really is that road is right next to an elementary school with a huge playground area. I assume some kid picked it up and thought it looked cool or made a nice sword or someting.

I'm going to make up somer "Missing - $50 Reward" flyers tomorrow and go door to door, but I'm not holding up much hope on getting it back. :

The piece was part of a Group Buy on ASEClub.net back in 2006, so finding a replacement in Carbon Fiber is impossible. So I figure if I could get a stock 97+ Eclipse piece, I can wrap it to match. But Eclipses are pretty scarce around my neck of the woods, so I'm really hoping you guys can help me out. Thanks in advance!!!

With that being said, I am looking to purchase the following:

a)
A 97+ Eclipse GS/GS-T/GSX OEM Passenger Side door molding (skirt). I will take just that one side, a pair, or the entire set if I have to. Worse case I can wrap an OE or FG version of it. Help me out!!

If you have something, PM me, email me at joshmcneer@hotmail.com or give me a call at 641-831-4680

95 Avenger 2.0 - Hahn 16g, DMS 8 injector setup, UDP, Big FMIC, HKS SSQV, MSD Coil & Wires,
ZEX Nitrous System, QTP Cut Out, Mandrel 2.5" Exhaust with cat delete, MP 60mm TB...and tons of Carbon Fiber

Bump.. No one can help me out?

95 Avenger 2.0 - Hahn 16g, DMS 8 injector setup, UDP, Big FMIC, HKS SSQV, MSD Coil & Wires,
ZEX Nitrous System, QTP Cut Out, Mandrel 2.5" Exhaust with cat delete, MP 60mm TB...and tons of Carbon Fiber