I know that the factory turbo's use this. I would really like to get my hands on that one if possible. I have a Garrett t3/t4 if that helps. Not exactly sure on the thread size.

Built block.
Refinished head.
Tuned suspension.
TURBO.

i have these. new but the crush washers were used so you will need new crush washers.

http://www.atpturbo.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=ATP-FTG-003&Category_Code=GTBB


They were 22.00 new I will give them both to you for 22.00 shipped


you can thread whatever fitting into the banjo to run rubberline or Braided or whatever you like. They take a 1/4NPT fitting which if you wanted you could get barbed fittings at home depot to run a 3/8 or 1/2 rubber hose.

Terry

I was able to get my hands on the ones I was looking for. The big thing for me is the longer line keeping it metal until it completely clears the turbo. What I use now crack eventually then leaks everywhere. Plus it is cumbersome. I think just going banjo will clean it up, but the fewer fittings the better.

I will let you know if I need them, because you never know, they may not fit properly or something.

Built block.
Refinished head.
Tuned suspension.
TURBO.

bet bet is to get the fittings like i have and run alum hard line to clear the turbo as your describing.

let me know if you do need them otherwise good luck and hope you get it resolved.

Can you tell me more about what you are using? Where can I get them?

Built block.
Refinished head.
Tuned suspension.
TURBO.