I've decided that I want a motorcycle so I'm selling the motor I had built for my car. The motor has never been used and all the parts are still brand new. The engine was built with the following parts: Clevite 77 Rod Bearing Set, Clevite 77 Main Bearing Set, One forged callies stroker crank shaft, Total Seal Piston Rings, Mopar Oil Pan Gasket Set, Melling Oil Pump, Eagle Specialty Forged Rods, JE Pistons, Eaton PT Cruiser Lash Adjusters (Lifters), PT Cruiser Cam Followers (Rockers), Dayco Timing Belt, Mopar Complete Head Gasket Set, Crane DOHC Cams 180/431-0016 turbo grind cams, AEM Adjustable Cam Gears, Crane Valve Springs and Retainers. The parts alone that went into the engine were over 3000 dollars. I'm only asking three for it.

I also have a bunch of other stuff that I'm selling:
- 2 Kosei K1 Racing wheels in white with mickey thompson slicks on them - $250
- A walbro 255 - $50
- A manual transmission with new clutch- $250
- The empty talon shell (no rust) with eclipse front and rear bumper - $500
- Aeromotive 1:1 FRP - $50
- Axles - $25
- Intake manifold - $20
- 2 1/2 inch headers back exhaust - $40
- Fiberglass Drift front bumper - $30
- A boost and EGT gauge with the tach gauge pod - $50

I'm intrested in the FPR do you have any pics?

Status- Need to do break-in...



Try not to challenge me, I'd rather tie up than lose. Either way you NEVER WIN.... - Me..

I'll take the walbro fuel pump. and possibly the transmission depending on where your located.

I'm located in West Chester, PA. I can take pics of everything this weekend.

I'm located in western PA, and will be out at Bloomsburg this weekend.

i could probably meet you on sunday with it.

come on guys make me some offers i'm very flexible.

Man, I wish you had posted this a month earlier, then you'd be sending that engine to me, but i no longer have the 3K that you're asking for it. Any chance in a price drop?

Banned

make an offer man

if this car has the later version of the fuel system(like on a 99), can you saw off the ends of the stock fuel hard line (about 4" of line with the fitting attached) on the end near the FPR/fuel filter, and on the other end that connects to the flexible line that is connected to the fuel rail.

much thanks!

2gnt: '99 RS-T, killed by a toyota, pending rebuild...
Daily: Volt
Daily #2: '99 EVG ebike- STOLEN by PEDRO

it was the 95 system sorry man

pics of the exhaust?

this weekend ill take pics of everything

would u separate the head?

probably not. i would like to sell it as a whole. how much would you offer for it??

2500 for the motor... anybody??

if you part it out, ill take the headlights as mine are so crapped up, i might as well drive without the lights are since they dont make a difference just shoot me a pm and let me know

Striped and left for dead now rebuilding
96 Eclipse Rs will be T again soon
Cold Air intake, Megan Header, N1 Cat back exhaust, test pipe, UDP, Drum To Disc Conversion, OBX throttle body spacer

i have the headlights off but they are a little foggy if thats okay. and someone please make an offer on this engine. 3000 is already a pretty good price for it.

not to be a PITA but pics of the exhaust?

pm sent

Heres pictures of what I have off so far. I also have an msd ignition coil and accel wires (picture) for $70 and a starter (picture) for $20. I will have the rest of the pictures this weekend and I will be able to ship out on monday.

Alright guys I have a few things sold a few things.
Engine - Sold
EGT and Boost Gauge- Sold
Intake manifold -Sold
Exhaust - Sold
Drift Bumber - Sold
FPR - sold

Still have
MSD Ignition Coil with Plugs - $70
Starter - $20
15" Kosei K1 with slicks - $250
Walbro Fuel Pump - $50
Axles - $25
Gauge Cluster Gauge Pod - $20
Talon Shell - $400