#110514, "Part out - 95 gs lots left car's going soon" Mar-14-08 09:54 AM by cs82685
I can finally get back to tearing into this car and am going to pull off as much as I can over the next two weekends then I'm getting rid of the car. If there's something you want but don't see let me know. All parts are obo, some more negotiable than others. A few popular items still up for grabs.
rear disc conversion ($150+ shipping) Passenger exterior door handle $15 shipped axles - make offer radiator - $50 shipped virtually all interior - make offer valve cover $30 shipped intake manifold $40 shipped crank pulley $15 shipped cams/gears $10 for each gear, $40 for the cams, everything for $50 5spd swap parts (minus actual trans cause I'm not getting into shipping large items just yet) - make offer headlights $70 shipped front calipers - $30 shipped for both or $20 for one any suspension parts fans - $10 each + shipping complete head - one spark plug helicoiled - make offer oil pan - make offer alternator - $35 shipped
Stuff that's NOT available throttle body intake hood front bumper tail lights ECU throttle cable side markers reverse lights block trans wiper assembly coil pack plug wires
If asking for some small obscure part, a picture helps a ton but not necessary
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#110524, "RE: Part out - 95 gs lots left car's going soon" In response to Reply # 2 Mar-13-08 11:45 PM by cs82685
Originally posted by Boofer97rs power door panels?
grey power door panels pics in link in first post
Originally posted by Domestic Killer PM'd
didn't receive a pm
Added link to original post with where I'll be hosting all pics of parts
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#110534, "RE: Part out - 95 gs lots left car's going soon" In response to Reply # 7
Originally posted by bahhaha PM 'd
replied
Originally posted by Domestic Killer PM'd again
repied
Originally posted by ez If it's not stripped, I could use the long bolt with nut that goes at the end of the fork through the bushing on the bottom of the front suspension.
I'll check for you
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#110541, "RE: Part out - 95 gs lots left car's going soon" In response to Reply # 8
I need all of the bumpstops, strutmounts, and bushings for all 4 struts. I an buying new struts and springs, and I will need everything else needed to complete the strut assembly.
#110547, "RE: Part out - 95 gs lots left car's going soon" In response to Reply # 10
Originally posted by fresh95 I need all of the bumpstops, strutmounts, and bushings for all 4 struts. I an buying new struts and springs, and I will need everything else needed to complete the strut assembly.
I'll get back to you on that one
Originally posted by Malenko center vent, just the actual vent parts but if you dont want to separate I understand. I also need some extra brass screws
It's yours make me an offer
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#110551, "RE: Part out - 95 gs lots left car's going soon" In response to Reply # 11
Originally posted by cs82685
Originally posted by fresh95 I need all of the bumpstops, strutmounts, and bushings for all 4 struts. I an buying new struts and springs, and I will need everything else needed to complete the strut assembly.
I'll get back to you on that one
Originally posted by Malenko center vent, just the actual vent parts but if you dont want to separate I understand. I also need some extra brass screws
It's yours make me an offer
Do you have the driverside splash guard outer, not the inner thats protects the trans.pan
Search
Printer-friendly copy
0 Users in Chat
