So the part out begins. These items are located in Austin, TX.

I have first the 3 gauge a-pillar from lo-tek. They are for 2 1/16" gauges but I enlarged the holes with a dremel to fit my 52mm Greddy gauges. I do not have the mounting screws or screw caps. $30 shipped.

I also have an Autometer 2 gauge cluster bezel for a 2g. They are also for 2/16" gauges. $40 shipped.

I have a Crane Ignition system. It consists of the following pieces:

HI-6DI2 CD Ignition for Distributorless Engines 6000-6500
Dual Channel Electronic Trigger 6000-8953
TRC-2 Timing Retard Control 6000-6425
GM 3 Bar MAP Sensor for timing retard
Mounting Bracket for Ignition and Trigger
Mounting Bracket for MAP sensor

Almost every connection is setup with a weatherpack connector. I put them there if they didn't already have them for ease of installation and removal. I am selling these as a SET. I will not break this up at this time. $450 shipped.

Below is a picture of the mounting plate with the ignition and the trigger on it. I will include the screws to mount the ignition and trigger to the mounting plate.


More pictures are available by request. Please email me through the forum and do not send me a PM as I may not check the board on a daily basis. Thanks.

-"Easy Mac"
05 Mazda RX-8 (RR8 #88)
99 Eclipse RS 398whp & 372lb-ft

WHAT in the HELL are YOU DOING?

That is all...

I edited to the wiki!

What about those hard to find relatively rare wheels you have... something tells me you're holding onto those.

2016 WRX STi Limited (current)
2001 A4 1.8tqms (donated)
1991 GVR4 #1933 (sold)
old.dsmregistry.com/detail.php?carid=218 (dismantled)