Need a flexplate with trim ring and bolts for a 95 neon conversion to late model modular clutch.

Shipped to 60544

u talking about from a nvt 350? if so ive got the flexplate and bolts and scatter shield

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on

All I want is the Flexplate (which is the same auto or manual) the trim ring that is required and the bolts.

To my knowledge no one makes a scattershield for our trans. You prolly referring to the dust shield that bolts to the block.

Terry

k i got that and also ive got the evap solenoid that you want if its the thing that is covered by a rubber shield? 60 shipped for all priority

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on