Really, that many people have had problems? I didn't realize it was THAT MUCH of an issue. Hmmm, maybe I'll just mount it on the passenger side of the center console, or on the floor board. Then again, I don't think it'll be TOO hard to run the wires through the firewall at that grommet. I have my wideband cable going through there. I just hope I have enough harness to get up to the coil without having to extend any of the wires.

I contacted MSD about the harness, but they still haven't called me back yet...guess I'll be splicing.

96 Indy Red Dodge Avenger I4 5spd
225.7whp/227.2wtq @ 10psi, currently running 12-14psi.
HRC Stage III turbo setup
JE 8.8:1 pistons
Eagle rods
block bored .020" over
GReddy FMIC w/ custom piping
1G crushed BOV
SPEC Stage 3 clutch
2.5" DP, 2.5" high flow cat, 3" ERT catback w/ Magnaflow muffler and 3" tip.
much much more...