I got my accel injectors yesterday and got them installed. They are 40 lbs/h injectors. So I decided to make the big jump and let ms run them. Terry built my ms and sent me a few maps to get me started. I am just having problems getting this thing started. I have the 6400 map sensor and one of the maps he sent me had the b&g sensor setting. So after about 3 hours of tring to get the car started I used this map not knowing that the b&g was selected. The car started and ran pooly but it started! I then turned the car off and changed the map to 400 kpa and the car starts. I let it warm up and turned the car off. I tried to start it and it wont start again. I have to select the b&g sensor to start the car then kill it and change the sensor to 400kpa everytime I try to start the car. There has got to be a better way.
Here i what I have and my settings 40psi idle fp 7.9 req fuel 1.0 injector open time .10 correction pwm% 100 threshold 25.5
I have wide band selected and my 14.7 voltage is 2.45 so thats what I put in the ego switch point at.
