1st off you'll notice I baught the stronger hex type bolts.(above)
I compair them below

Tie a thin strong rope to (2) 8mm fine pitch blots and give it a few tugs

The pump is out!

After removeing the Pump cover (the shaft comes with it) this is what you'll see.

Inspect the shaft for burs and burns.. as u can see this shaft is burnt to hell and needs to be replaced

Remove and inspect inner gear. (this looks fine)


Remove and inspect outer gear (again fine)


And believe it or not thats it.... use a very very thin layer of RTV when sealing the pump assem. In this pump all we have to replace is the cover/shaft assem.

If there are any ques let me know




mods include but not limited to:
engine: AEM cai , pp head / TB / intake runners, Chikira 4-2-1 header , custom 2.5" exhast / pacesetter high flow cat/flowmaster2 muff,1mm over sized SS valves,PT valvetrain, AEM cam gears/pully set, prothane motormounts,440 injectors , ground kit.
Trans: Custom ATX (1 of a kind) poly-graphite steels , kevlar clutches , final drive , shift kit,3500 stall TC, Tourqe Wonder trans chip ($120.00 2gnt price only!!email for order info)