#11751, "RE: Need Help Buildin' Ported Box To Spec...." In response to In response to 2
Originally posted by VOTBLINDUB
Originally posted by SPL_Eclipse a few things: 1) you listed the port as being 4"x12", but made no qualification as pertains to a dimension. you later listed a round port diameter, but made no mention of depth. based on your box size and tuning, i imagine you'd want a 4" round port with a depth of around 12". that should give you about a 35hz tuning, like you are looking for. 2) you want to make two 3+cu. ft. boxes? thats a LOT of room to take up, and unless you are willing to 'glass, they both wont fit in the hatch of an eclipse. which brings me to... 3) is this for a 2GNT?
1) i think he is not sure what port to use round or square. it doesnt really matter as long as its calculated properly. 2) i wouldnt say its not possible to fit 2 boxes that big in the car. i do not think it will all fit into the trunk without some modification. hed have to take off the plastic panels and glass the sides to use all that space, then take out the spare and use that dip in the floor for more space. it would be a tough fit, but it is possible. another way to get around that is to take out the rear seat and make the boxes protrude forward and sit partially where the seat was. 3)as long as its not a festiva it sounds doabl
When you mentioned the dip/spare tire space, I recalled wantin' to ask you about that. I wanted to ask if you knew how to remove that metal sh!t that holds the tire in place. The only way I could think of was to have it cut off, I didn't notice any type of bolts on the base....
