#2069, "RE: 034 EIC....I need an EXACT resistor and map" In response to In response to 14
That's the thing. I haven't installed the MSD yet so I don't know which'll be easier. I should first ask, how hard is the MSD to install? Secondly, if I were to go that route, where would the tach line need to be tapped from so I don't need the resistor? Anyone have a diagram or schematic of this?
96 Indy Red Dodge Avenger I4 5spd 225.7whp/227.2wtq @ 10psi, currently running 12-14psi. HRC Stage III turbo setup JE 8.8:1 pistons Eagle rods block bored .020" over GReddy FMIC w/ custom piping 1G crushed BOV SPEC Stage 3 clutch 2.5" DP, 2.5" high flow cat, 3" ERT catback w/ Magnaflow muffler and 3" tip. much much more...