ok, i just put my tranny back in, i replaced master cyl, slave was fine, bleed the lines, and the clutch SORT OF stiffened up. so i put it in gear, let out the clutch, and you can hear something spinning or something inside my tranny somewhere... i dunno. but then, the pedel went to nothing and i can't get it into gear. it is in neutral when i start it obviously, but when i go to put it in gear, i can hear it bogg the engine down a bit. its a brand new stock sachs's clutch.

would i know if the TOB fell off inside the housing when i put it on? i was sorta afriad of that...

I can see the master cylinder moving too....im lost. i dunno if it moves enough thou.... is there any sort of adjustment on the slave cylinder to help engagement or anything?

Having Problems? Heres my Three step solution to anything 2gnt related.
Step 1: Put down everything in your hands.
Step 2: Grab a lucky strike, Smoke it.
Step 3: Walk to the fridge, double fist some keystone ice, sit down in the shade, drink one beer, finish cigarette, drink other beer, roll a joint, smoke it, walk back to your problem, and in about 5 minutes the solution will come to you.
If not. Go here: here

If still nothing, your trying to hard. Start over at step 1.