|
Seriously, you guys are a little biased. You all bitch about your AT but never tried to make them any better. Anyone do the final drive mod and see how much it helped? Shift kit?
Sure you are going to be a little faster with the MT. Duh, it's geared differently, it's lighter, and there is less loss through the driveline. Shocker! If you knew what you are doing I doubt it'd be 1.5-2 seconds. Probably closer along the lines of .5 or less.
Just for the record Matt Deimos' time was 13.8 @ 106 in his AT RS at the 2k4 shootout. He ran faster than I did that day (14.0 @ 105) and we had similar mods (s20g @ 15psi). His car also drove home, mine didn't.
Also, its not like those of us over 300whp are running run of the mill stock MTs either. We're all sitting with LSDs, race axles, short shifters, heavy duty clutches, and 3.55 transmissions. If you were an AT at that point you should have a shift kit, final drive mod, trans cooler, LSD, higher stall TQ converter, and axles. It'd probably be about the same in the end cost wise.
Anyways, my point is don't go auto bashing. Sure your car will be slower than a MT but not by 1.5-2 seconds. Remember that if you're sitting in a 5spd you still have to launch worth a damn. Those good 60' times are hard to get. It's pretty easy to get off the line in an AT. In my opinion, the only and BEST reason to get/swap in a 5spd is because you like the feel of it. Shifting through gears, feeling in control of the car. Oh, and if you like AutoX it's kinda nice to have. -"Easy Mac" 05 Mazda RX-8 (RR8 #88) 99 Eclipse RS 398whp & 372lb-ft 

|