You guys with the flex-a-lite fans, how did you mount it. I'm having problems with the brackets so I guess I will have to make custom brackets. I went to home depot to find brackets, but I couldn't find anything I can use. Please post some ideas. Thanks

HRC S16G. FMIC. 8.5:1 JE PISTONS. CROWER RODS.



engz
www.cnnmotorsports.com | http://www.cardomain.com/id/el2ocz33

honestly? i just used black zip-ties thru the factory bolt holes on the radiator. two per hole. they have lasted over a year without signs of wear or decay!

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

For our V6 turbokits, space is very limited. We completely remove the stock fans, and use 2 universal FAL 12inch PUSHER fans, and mount them in front of the AC condensor/radiator. We have had no major overheating issues with this setup. Steve (owner) has been using this design for over 3 years, and we've found that there is no better way of doing it. Here's a picture of an Avenger with our setup.

EDIT: This also leaves room for many things. IE: Bigger turbo/downpipe etc


Hope this helps
Chris

i used big washers and bolts that i went to lowes and got and mounted them to my fluidyne

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on