#80096, "Anyone try one of these DSM fuel rail fittings?"
It goes on the Rail inlet and has a -6AN end. It's exactly what I need, but does the o-ring side fit? Is it the same size as our rails? Seems like it would work, but I just want to be sure.
____________________________________________________ four nails four corners four riders and four horses
#80097, "RE: Anyone try one of these DSM fuel rail fittings?" In response to Reply # 0 Dec-06-04 03:42 AM by tim97rs
its useless. If you used that on an otherwise stock fuel rail, that little tube that goes into the main rail from the inlet is still a 4an.
the best thing to do is chop the inlet off the rail, seal it, and drill out the end and weld that 6an one on there.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#80106, "RE: Anyone try one of these DSM fuel rail fittings?" In response to Reply # 2
Originally posted by MrSlick must be compensating for something
Well no shit. Look at his cars - he's gotta be hung like a tuna can.
______________________________ If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.
'95 Eclipse TurboGS (garage deco) '95 TSi AWD (restoring a survivor) '97 Talon ESi-T (poor impulse control) '99 Eclipse RS-T (daily beater) '13 Evo X (mostly stock) '17 Sienna (Middle Aged Dad Mobile)
#80316, "RE: Anyone try one of these DSM fuel rail fittings?" In response to Reply # 2
Originally posted by MrSlick As far as I know the sizes are different... And I have a 4g63 fuel rail out the back if you want me to take measurements off it so you can compare and get upset. For all the work it would be to hack up the stock rail, I'd just buy an aftermarket rail if you want more fuel. But then I run the stock rail and have no problem getting fuel... Etx just likes to have everything big... must be compensating for something
Eh, no. I had a small -6AN braided line laying around, it's perfect to go from the hard feed line to the rail inlet. So I figure I'll use it I just need to go from that -6AN into the rail which uses a 7/16" o-ring adapter. If I could find a steel -6an weld in thing that would work. Or have someone Tig a -6an onto the rail. And I DO have an after market rail, and unlike my unit the Rail is huge.
Originally posted by DarkOne
Originally posted by MrSlick must be compensating for something
Well no shit. Look at his cars - he's gotta be hung like a tuna can.
Yep! Didn't I publicly announce that at the 04' Shootout?
____________________________________________________ four nails four corners four riders and four horses
#80326, "RE: Anyone try one of these DSM fuel rail fittings?" In response to Reply # 7 Dec-10-04 12:50 PM by thedawg
Originally posted by etx Eh, no. I had a small braided lay around, it's perfect to go hard to. So I figure I'll need to go. If I could find a thing that would work. Or have someone like my unit huge.
Originally posted by DarkOne he's gotta be hung like a tuna can.
Search
Printer-friendly copy
1 User in Chat
