It goes on the Rail inlet and has a -6AN end. It's exactly what I need, but does the o-ring side fit? Is it the same size as our rails? Seems like it would work, but I just want to be sure.

its useless. If you used that on an otherwise stock fuel rail, that little tube that goes into the main rail from the inlet is still a 4an.

the best thing to do is chop the inlet off the rail, seal it, and drill out the end and weld that 6an one on there.

As far as I know the sizes are different...

And I have a 4g63 fuel rail out the back if you want me to take measurements off it so you can compare and get upset. ;)

For all the work it would be to hack up the stock rail, I'd just buy an aftermarket rail if you want more fuel. ;)

But then I run the stock rail and have no problem getting fuel...
Etx just likes to have everything big... must be compensating for something ;)

Originally posted by MrSlick
must be compensating for something ;)

Well no shit. Look at his cars - he's gotta be hung like a tuna can.

Originally posted by DarkOne

Originally posted by MrSlick must be compensating for something ;)

Well no shit. Look at his cars - he's gotta be hung like a tuna can.

lol



best time so far 14.3 @ 101.1mph(no traction)
www.cnnmotorsports.com

I got the same answers a while back.... well cept for the comp. comments.


What can I say, some are more "gifted" then others...I thank thee lord

Originally posted by MrSlick
As far as I know the sizes are different... And I have a 4g63 fuel rail out the back if you want me to take measurements off it so you can compare and get upset. ;) For all the work it would be to hack up the stock rail, I'd just buy an aftermarket rail if you want more fuel. ;) But then I run the stock rail and have no problem getting fuel... Etx just likes to have everything big... must be compensating for something ;)

Eh, no. I had a small -6AN braided line laying around, it's perfect to go from the hard feed line to the rail inlet. So I figure I'll use it I just need to go from that -6AN into the rail which uses a 7/16" o-ring adapter. If I could find a steel -6an weld in thing that would work. Or have someone Tig a -6an onto the rail. And I DO have an after market rail, and unlike my unit the Rail is huge. :P

Originally posted by DarkOne

Originally posted by MrSlick must be compensating for something ;)

Well no shit. Look at his cars - he's gotta be hung like a tuna can.

Yep! Didn't I publicly announce that at the 04' Shootout? :7

I just ordered one of these, I'll try welding it up. It will probably suck. ;)

http://www.bakerprecision.com/adapt13.htm

Originally posted by etx
Eh, no. I had a small braided lay around, it's perfect to go hard to. So I figure I'll need to go. If I could find a thing that would work. Or have someone like my unit huge. :P

Originally posted by DarkOne
he's gotta be hung like a tuna can.

:whoa