ok, i recently had my compression test done with my #3 cyl coming in at only 50.....i had a lot of oil blow-by out of my crank case breather....so today i rigged up a hose from the breather into my oil return line using a "T" connector thinking it it solve the blow-by problem till i had a compression leak test to pin-point my problem. well i hooked up my oil return-return line and took it for a drive.......well i punched it to test it out and my motor started smoking BAD! and out of my exhuast!....i popped the hood and oil was still being shot out of somewhere (head gasket?). so this whole time i thought the oil was coming out of my crank breather but it wasn't.....so what causes the oil to spew all over my battery area in my engine and OIL ON MY EXHAUST? it's white smoke also.......i think it's my head gasket, would that cause a low compression test?

anthony...another victim of the boost addiction.

>ok, i recently had my compression
>test done with my #3
>cyl coming in at only
>50.....i had a lot of
>oil blow-by out of my
>crank case breather....so today i
>rigged up a hose from
>the breather into my oil
>return line using a "T"
>connector thinking it it solve
>the blow-by problem till i
>had a compression leak test
>to pin-point my problem. well
>i hooked up my oil
>return-return line and took
>it for a drive.......well i
>punched it to test it
>out and my motor started
>smoking BAD! and out of
>my exhuast!....i popped the hood
>and oil was still being
>shot out of somewhere (head
>gasket?). so this whole time
>i thought the oil was
>coming out of my crank
>breather but it wasn't.....so what
>causes the oil to spew
>all over my battery area
>in my engine and OIL
>ON MY EXHAUST? it's white
>smoke also.......i think it's my
>head gasket, would that cause
>a low compression test?
>
>anthony...another victim of the boost addiction.
>

meant to say oil IN my exhaust.......as in coming out of my muffler

anthony

sounds like cracke piston/broken piston seal

l e o n

You have cracked pistons. And the oil in the engine bay is coming from that breather in your valve cover. Not bad only one piston. I cracked three. What were you boosting?

no i think it's my head gasket........i ran a tube from my crank case filter to the ground and i was still getting oil in my engine bay........and now i'm getting water and oil in my exhaust.......i hope it's only a bad head gasket......

anthony

oh yeah i'm only boosting like 8lbs so i hope it's only a head gasket......

anthony

With compression like that, i'm willing to bet it's not just a head gasket. Sucks, dude, but i think you've cracked a piston or two.

Sorry to hear it. I might be next.


-DarkOne
I'm so bad, i should be in detention.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

I had the exact same thing, I mean exact same thing, even in cyl number 3 and teh compression was 33 I think, Did you try putting oil doen teh cyl to see what happened? I did and it rose back to 150is, from what I hear that is a blown seal on teh piston, I'm upgrading with a whole new bottem end so.........

Shant 98 Turbo Avenger

well i put the car in the shop today.....hopefully i'll now something soon.......i got Je pistons (rings and all) and crower rods for 1200 out the door.....wait and see about the valves.......with this setup and my star stage II fuel setup (factory injectors) what kinda boost can i run?


anthony....another victim of the boost addiction