I finished hooking up my nitrous a couple days ago and when I tested it, it worked great. Today I went out to play and it BOGGED! WTF! Nitrous is on, purge works great. I have brand new NGK plugs -which I did not gap differently because the stock setup worked great on my talon. I ran the kit through about 5 bottles w/ 75 shot on my 2g talon and had no problems at all. The only difference is that I am now using an AEM intake and I tapped the fuel rail instead of cutting the line. I dont know why its bogging. I guess its getting too much fuel. I have no backfire or anything. Any ideas on why its bogging on me? I searched and found some w/ the direct port but didnt find an answer.
#68728, "RE: Nitrous Bog!!!" In response to Reply # 0
Well i will tell you this. I had my n20 and 35shot was great. Went to 50 and it bogged, I checked everything and it bogged again. Then I came to idle and had a rough idle. I fried a valve.
#68736, "RE: Nitrous Bog!!!" In response to Reply # 3
bottle pressure? i think if you dont have the optimal pressure youll get less nitrous flowing through than you should....hence too much fuel. maybe..im just guessin
#68837, "RE: Nitrous Bog!!!" In response to Reply # 0
Originally posted by wickedtalon I finished hooking up my nitrous a couple days ago and when I tested it, it worked great. Today I went out to play and it BOGGED! WTF! Nitrous is on, purge works great. I have brand new NGK plugs -which I did not gap differently because the stock setup worked great on my talon. I ran the kit through about 5 bottles w/ 75 shot on my 2g talon and had no problems at all. The only difference is that I am now using an AEM intake and I tapped the fuel rail instead of cutting the line. I dont know why its bogging. I guess its getting too much fuel. I have no backfire or anything. Any ideas on why its bogging on me? I searched and found some w/ the direct port but didnt find an answer. Jim
How is the temp there? Is it cold? Becuase I know the bottle pressure varies A LOT depending on temp. Like ~60F the pressure would be 900PSI compared to ~40F around 600PSI. What about the jet size? Right one in the right place?