#63754, "Question about Oil inlet on the HRC 16g hole size in bottom"
on my HRC 16g the hole that allows the oil to get to the shaft, at the bottom of the oil fitting inlet, is like sooper dooper tiny. its mabye only 1/16" or so big. does that seem right? anyone else have that size hole?
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#63760, "RE: Question about Oil inlet on the HRC 16g hole size in bottom" In response to Reply # 0
My 16G is on the floor right now and it looks like a 3/8 npt thread for the oil inlet and a 1/2" outlet for the oil return. Are you looking at the hole in the fitting that the 90* attaches to?. That is a -4AN fitting and that is the appropiate(sp) size for the fitting. Hope this helps.
#63768, "RE: Question about Oil inlet on the HRC 16g hole size in bottom" In response to Reply # 1
heres a pic. this is the inlet to the shaft. i noticed 2 holes on the sides as well as the one in the bottom. it just seems that that little hole is to small. is yours like that?
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#63799, "RE: Question about Oil inlet on the HRC 16g hole size in bottom" In response to Reply # 2
bizzle dizzump!
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
Search
Printer-friendly copy
1 User in Chat
