btw I searched.

I have an A'PEXi Turbo Timer and I didn't get the vehicle specific wiring harness and the instructions are only for the 4G63.
Q:Has anyone wired this up on there own? pics? tips? hints?
THANKS!

Evo 8 - 12.3@113 circa 2009 (~330whp)
Now with BB Xona Rotor HTZ FP Red and ~450whp
2018 MSM Civic SI Ktuner TSP stage 1 w/ Honda hacked headunit.

All the wireing is the same in the 4g63 so you can use the diagram. Also you could buy any harness made for the 4g63 and it would be plug and play. I used the greddy harness for the 4g63 car. The all you have to do is wire up the ground and the O2 sensor signal wire.

I edited to the wiki!

Thanks a bunch. I am so sick of siting in my car to wait for that sh!t to cool off.

Evo 8 - 12.3@113 circa 2009 (~330whp)
Now with BB Xona Rotor HTZ FP Red and ~450whp
2018 MSM Civic SI Ktuner TSP stage 1 w/ Honda hacked headunit.

You dont need to idle for more than a minute or so. Modern turbos don't need time to cool off nearly as much as their older counterparts.

1996 Eclipse RS / 5-Speed / Aerogear Body / Coated in Magnetic Red Metallic rev.2 / T3 Turbo Intercooled @ 8 psi / More at http://home.insightbb.com/~mgalyan/
Mark Galyan - Indianapolis, Indiana

oh? The shop were I used to live said that after running it real hard to wait about 3 min. but if I don't boost at all that I can just turn it off... but not boosting isn't fun

Evo 8 - 12.3@113 circa 2009 (~330whp)
Now with BB Xona Rotor HTZ FP Red and ~450whp
2018 MSM Civic SI Ktuner TSP stage 1 w/ Honda hacked headunit.

If your seeing temps from 1400-1600 for any length of time, such as driving on the freeway, I would give it at least a minute to cool.

Just open the steering column and get to the ignition harness. Break out a fluke meter and test the pins to find which one come when you turn the key to each spot. Then wire them according to the pinouts on the TT instructions.

I got apexi harness and I was not wired properly, I had to switch 2 wires to make it work. Simptoms of this would be the hvac fan will not come on when you turn the car on.

Good luck.

____________________________________________________
four nails four corners four riders and four horses

oh yea, the oxygen sensor has 4 wires. which is the signal wire?

Evo 8 - 12.3@113 circa 2009 (~330whp)
Now with BB Xona Rotor HTZ FP Red and ~450whp
2018 MSM Civic SI Ktuner TSP stage 1 w/ Honda hacked headunit.

Evo 8 - 12.3@113 circa 2009 (~330whp)
Now with BB Xona Rotor HTZ FP Red and ~450whp
2018 MSM Civic SI Ktuner TSP stage 1 w/ Honda hacked headunit.

___________________________________________

The hvac won't come on at all if you get the same busted wireing harness I got.

____________________________________________________
four nails four corners four riders and four horses

phew. mine comes on. i was thinking that maybe the fan was supposed to come on while timing to cool the engine down, i dont think mine does. alright, everyone, please proceed with your regular scheduled broadcasting.

___________________________________________

If you had to switch two wires, then you have a 1G harness, not a busted harness. I had the same problem, myself. I fixed it the same way, too.

-=B-=

Dude, Boeing called. They want their wing back.

Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate.
Me: Can I put that in my sig?
Dark0ne95: GO right fucking ahead.

Yeah when I got mine apexi did not have one for the 2g only the 1st gen. I assume it's still the same. The greddy harness will work correctly. The O2 wire is under the wire cover on the ECU I believe it is the white wire with the black stripe in the top portion of the harness. If you search on the board it has been discussed. That way you'll know for sure because I don't want to steer you wrong.

I edited to the wiki!