2 questions.

1)I just got my NX purge kit today. How do you bend the dump tube? Do you jsut heat it up and bend it?

2) I dropped the fuel rail fitting in my engine bay and it's gone. Does any one have a part number for it? It's for a NX wet kit

Home Depot warriors to the rescue

1) u can use your hands a small pipe bender tool.
2) im not sure what fitting you are talking about. The part that came out of the test port. or The part that goes on the end of the fuel line.

myspace.com/coastiecobb

yea, pipe bender. They're only a couple dollars at autozone. not sure what fitting you are talking about unless it the one w/ two female ends. Thats the only kind of fitting that I used.

// Jim // 95 Talon / 99 Eclipse (sold)

Cincinnati,OH

this red fitting?

Nos Fogger Kit,AemCAI, TopFuel UDP, pacesetter cat-back, ARD bored 57mm t.b., P&P intake mani, Ractive front/rear strut bars,rear tie bar,eibach sportlines,tokico blues, morosso wires, ngkIX plugs, konig subzeros,proj. heads,gunmetal tails, rev.indiglow gauges,reverse light mod

you can get an aluminum/copper pipe bender at just about any hardware store for cheap.

1999 Black C5
1997 Silver RS
Wiseco 8.8:1 Pistons(back to low compression!)
Eagle Rods
T3/T4 Turbo
Custom FMIC
Greddy Exhaust
390's
Most current 1/8th mile time: 8.3@90mph 2.015 60'(Nitto Drag radials, i suck)

Let me clarify the part I'm looking for. It's not the scherder(sp?) valve you take off, but the fitting you put in so you can tap it. I'm looking for the part number, its for a NX kit.

Home Depot warriors to the rescue

Go on the nos website and look at fittings under accesories. I think its just an aeroquip 4an fitting or something like that. NOS parts will fit on NX parts vise-versa

myspace.com/coastiecobb