2 questions.

1)I just got my NX purge kit today. How do you bend the dump tube? Do you jsut heat it up and bend it?

2) I dropped the fuel rail fitting in my engine bay and it's gone. Does any one have a part number for it? It's for a NX wet kit

1) u can use your hands a small pipe bender tool.
2) im not sure what fitting you are talking about. The part that came out of the test port. or The part that goes on the end of the fuel line.

yea, pipe bender. They're only a couple dollars at autozone. not sure what fitting you are talking about unless it the one w/ two female ends. Thats the only kind of fitting that I used.

this red fitting?

you can get an aluminum/copper pipe bender at just about any hardware store for cheap.

1999 Black C5
1997 Silver RS
Wiseco 8.8:1 Pistons(back to low compression!)
Eagle Rods
T3/T4 Turbo
Custom FMIC
Greddy Exhaust
390's
Most current 1/8th mile time: 8.3@90mph 2.015 60'(Nitto Drag radials, i suck)

Let me clarify the part I'm looking for. It's not the scherder(sp?) valve you take off, but the fitting you put in so you can tap it. I'm looking for the part number, its for a NX kit.

Go on the nos website and look at fittings under accesories. I think its just an aeroquip 4an fitting or something like that. NOS parts will fit on NX parts vise-versa!:thumbsup