Just as the title says.
TIA
Nick
97RS

turbo8u> shut your SUCK

I think it should be fine. I have the 5/8 that came with my NER kit. It's way bigger than the feed line is.

Built 420a
NER turbo kit T3/T04s ball bearing
AFX UDP
Crane 0014 cams

5/16"???

dude NO!

-6an minimum bigger then the feed by atleast 25%

i used 5/8" or -8an line for dump tube...

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

>i used 5/8" or -8an line for dump tube...

Bill, -8AN is 1/2". -10AN is 5/8".

An AN numeric size is the numerator of a fraction with a denominator of 16.

EX: 3/8 = 6/16 = -6AN
EX: 1/2 = 8/16 = -8AN
EX: 5/8 = 10/16 = -10AN

On a side note, I'm using -10AN stainless steel braided drain.

hey i was 1 size off i knew it wasn't 5/16 thou =)

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

Psshhhh... SUUUURE... you know you've been planning on running a -5AN line on your personal setup. j/k... keep up all the hard work supplying parts to 2gnt man... I'll be posting pics & vids of my setup this week... I finally bought the correct firewire cables.