#46478, "RE: 4G63 fuel rail" In response to Reply # 0
Well theroticly you could use any fuel rail because you will be drilling the holes, so unless it hits the side of the runners then you're fine. I think that Corbin advised against using it, but I may be wrong. Search for a post "would you trust JB weld to do this" I believe that is where it came up.
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
The spacing is not so drastically different that it wont work. I had it all lined up and marked out on the manifold. It got close to the edge, but it looked like it would have worked just fine.
I WAS going to use that rail but have since changed my mind. I'll be using a 2gnt rail now.
#46514, "RE: 4G63 fuel rail" In response to Reply # 5 Apr-10-03 06:10 AM by Kirby
The Neon rail has crappy flow, and the spacing may be different. Plus I don't know if there are any neon rails in the proper config. to hook up the 8 inj setup. You can try MS recycling or Bob Kise, either way you will pay around $50 for the rail. Or you can try to find a member with one but good luck there. Edit: here you go Greg get it quick http://forums.2gnt.com/dcboard.php?az=show_topic&forum=16&topic_id=10745&mesg_id=10745&page=
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
Search
Printer-friendly copy
4 Users in Chat
