Anyone noticed if there the same injector spacing as us or can be used in say and 8 injectors setup??

Well theroticly you could use any fuel rail because you will be drilling the holes, so unless it hits the side of the runners then you're fine. I think that Corbin advised against using it, but I may be wrong. Search for a post "would you trust JB weld to do this" I believe that is where it came up.

The spacing is different, but not so bad as not be able to use the rail for your secondaries.

Yeah, that did turn out to be a pretty good thread - http://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=43248

The spacing is not so drastically different that it wont work. I had it all lined up and marked out on the manifold. It got close to the edge, but it looked like it would have worked just fine.

I WAS going to use that rail but have since changed my mind. I'll be using a 2gnt rail now.


95 Eclipse RS : 5 speed
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html

Will the neon Fuel Rail work?? Or anyone have a spare 2gnt one laying around?

I don't know about the Neon rail. I do have a spare 1g rail, want it?


95 Eclipse RS : 5 speed
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html

The Neon rail has crappy flow, and the spacing may be different. Plus I don't know if there are any neon rails in the proper config. to hook up the 8 inj setup. You can try MS recycling or Bob Kise, either way you will pay around $50 for the rail. Or you can try to find a member with one but good luck there.
Edit: here you go Greg get it quick http://forums.2gnt.com/dcboard.php?az=show_topic&forum=16&topic_id=10745&mesg_id=10745&page=