I use my snap on computer on my eclipse and the code p10108 comes up. The codes means that to much voltage is flowing from the o2 sensor. I clear the code and it comes back later. Is their a fix for this. Thanx

Your Garage is not worthy
For the Masterpiece you built
That only looks like it cost a Fortune
While most flaunt their cars by going fast
You show off Standing Still

well you might have a short between the signal wire and the voltage input wire, or your running sooooooooooo rich that its causing problems with the ECU

Your gonna have to hook a voltmeter up to the signal wire at the ECU (white wire with black stripe) and check voltage at idle and Wide open throttle

it should be from 0-1.2vdc max, if its 5 vdc or so you have a short between the input voltage wire (the one for the heater part of the o2 sensor and the signal wire)

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Your O2 sensor is shot. Replace it.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/