I installed it like I had my MBC installed. It does not work. It will not control the boost. Here is how I have it...
Turbo ---> Selonoid In / Selonoid Out ----> Wastegate
That is the way that Dino told me to do it, and that is the way that I had my MBC. The guy at the local "performance" shop that sold it to me told me that it had to be installed like the directions said. Here is what they say...
Now. Which way is correct for our application? I figure that I am going to rerun all the vacuum lines so that it is like the instructions, but I am not going to tap into my IC piping before the TB, I will just take a port off the TB.
#27677, "RE: Anyone ever installed the Blitz SBC-ID?" In response to Reply # 0
not trying to be retarded or anything, just covering the basics.......did you hook up the head unit a manifold pressure line? the sbc-id should have a hose diagram similar to a profec-b (the solenoid only workes as a valve.....not a controller as ina mbc). the controller is electric (your head unit) and requires a "pressure signal" so I knows how much boost you are running so it can control it.
A.D.P. "...If you do too much, people become dependant. If you do to little, people loose hope. If you do it right, people won't be sure you've done anything at all." bring it on............
A.D.P. "...If you do too much, people become dependant. If you do to little, people loose hope. If you do it right, people won't be sure you've done anything at all." bring it on...........
#27679, "RE: Anyone ever installed the Blitz SBC-ID?" In response to Reply # 4
The SBC has a control module located inside the car and there is a vacuum line connected to that. I teed off from my boost gauge line to the control module.
I have a Tial wastegate, so I do have 2 ports on it, so that is not a problem. I guess I am going to try to install it like the diagram shows and see what happens.
Search
Printer-friendly copy
0 Users in Chat
