#23610, "Where should I get the vacume for the fpr line?"
Ok I installed the cartech FPR today and it seems to hold at 50psi base good enough. But my question is where do I get the tap for the two fittings on top, I'm guessing that one goes to the manifold and the other???? which do I use?
#23611, "RE: Where should I get the vacume for the fpr line?" In response to Reply # 0
For the signal, install a tee in the EGR Control vacuum hose coming off the back of the intake plenium. Run a hose from the tee to the FPR and connect it to the nipple that doesn't have a bleeder valve. Next, connect a small piece of hose (2-3") to the bleeder valve outlet on the FPR and the other end to the check valve.
Hope that helps... keep me updated on your install!
#23613, "RE: Where should I get the vacume for the fpr line?" In response to Reply # 2
The check valve allows boost pressure to come out of the bleeder valve when needed, but closes under vacuum. Otherwise, the bleeder valve becomes a vacuum leak when not boosting. You should've got it with your FPR. Is yours a used one from an HRC installation?
Search
Printer-friendly copy
1 User in Chat
