| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | Where should I get the vacume for the fpr line? |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=23610 |
23610, Where should I get the vacume for the fpr line?
Posted by RxR_Eclipse, Jun-01-02 11:26 AM
Ok I installed the cartech FPR today and it seems to hold at 50psi base good enough. But my question is where do I get the tap for the two fittings on top, I'm guessing that one goes to the manifold and the other???? which do I use?
|
23611, RE: Where should I get the vacume for the fpr line?
Posted by dougie2, Jun-01-02 12:44 PM
For the signal, install a tee in the EGR Control vacuum hose coming off the back of the intake plenium. Run a hose from the tee to the FPR and connect it to the nipple that doesn't have a bleeder valve. Next, connect a small piece of hose (2-3") to the bleeder valve outlet on the FPR and the other end to the check valve.
Hope that helps... keep me updated on your install!
|
23612, RE: Where should I get the vacume for the fpr line?
Posted by RxR_Eclipse, Jun-01-02 02:16 PM
Ok I think I got it, but on the last part where do I connect the second hose to, what 'check' valve are you reffering to?
|
23613, RE: Where should I get the vacume for the fpr line?
Posted by dougie2, Jun-01-02 02:38 PM
The check valve allows boost pressure to come out of the bleeder valve when needed, but closes under vacuum. Otherwise, the bleeder valve becomes a vacuum leak when not boosting. You should've got it with your FPR. Is yours a used one from an HRC installation?
|
23614, RE: Where should I get the vacume for the fpr line?
Posted by RxR_Eclipse, Jun-02-02 04:29 AM
Yea I got it used! So can I get this check valve anwhere? Napa, Schucks, ect, ect?
|
23615, RE: Where should I get the vacume for the fpr line?
Posted by Manek1, Jun-02-02 04:50 AM
yes.
|