what is a good EGT with everythign need to install for under 150? I CANT FIND A GOOD ONE FOR UNDER THAT. THat is as much as i am prolly gonna spend..thanks



AFX UDP
bkre6-11s
bosch wires
2.5 piping
test pipe
Tanabe muffler
HRC stage 1
A/F ratio gauge

email me at Anthonyl469@aol.com if oyu have
needed: EGT gauge/Blitz or Greddy BOV/FMIC/tan 2 or 3 pillar/bezel for 2 gauges/or nay other lil goodies cheap


"When you reach real ability you will be able to become one with the enemy. Entering his heart you will see that he is not your enemy after all." -Tjusii

1998 Integra Type R #0072

get the apexi one, it's like 320$, lol...

-bryan
'98 rst

Just buy the autometer gauge (~$100) and when I get home I'll find the receipt for where I got my $25 probe. It's an airplane shop but the probe is very good. It's so fast that it drops as soon as you let off the gas.

this is what i have, works great and only about 120

http://store.summitracing.com/partdetail.asp?part=23981',650,505,'ATM5744

You can get a greddy egt. Personally I think it's better looking and better quality than the Autometer. Hit up shaun over at New Edge Racing. He'll give you a good deal. Tell him Thura sent you. shaun@newedgeracing.com

-"Easy Mac"
05 Mazda RX-8 (RR8 #88)
99 Eclipse RS 398whp & 372lb-ft

I have an autometer gauge and a Team Rip probe.

http://www.teamrip.com/pricing.html
The probe is down towards the bottom of the page.

The probe cost $38 and it has a 20,000 to 50,000 mile life span. It is EXTREMELY fast and responsive. The probe came with a 2 ft wire that has a quick disconnect end on it. I had to buy 4 - 5 more feet of wire the first time but after this probe burns out I spend $38 and it takes 1 minute to put in the new probe.



________________________________________________________________________________________
current status - No 3rd Gear synchro


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

Flame Red SRT-4 GT40,8.5:1 Built Shortblock, Brian Crower Stage 2 Cams, etc etc etc...

I got mine at http://www.turbotrix.com (under misc, pyrometer)

It came with a probe and everything you need to install all for 130 bucks plus shipping.

16.1 @ 87.11
http://www.virtuallyinfamous.com

ARD 57mm tb and p&p manifold, Neuspeed STB, Pro-kits, Illuminas, Injen CAI with K&N, 2.5" pacesetter catback,
AF/X UDP, Rear STB, Powerslot rotors, RRE SS Brakelines.

got mine at turbotrix also 130 bux pyrometer. They sell them in 3 different style mine is a phantom. They said the probe is better than the EGT gauge's box one or something. It is quick acting also. Haha make sure you don't route the signal wire near the EGR tube like I did and melt that sucka.

http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr
Who sez FF can't drift?

Same thing happened to me. My EGT wire was melted to the EGR tube.

Dave
05 Ford F150 SuperCrew FX4

Same thing here. I ended up using zip ties to keep it away from that hot mother focker. I knew there was something wrong when my egt needle started jumping around.

97 RS(PTE SC-61, Built Long Block, Electromotive Tec 3)It's Here!

Whats wrong with the Apexi one? I think my El series meters are pretty damn cool looking. I installed mine Post-turbo though, is this ok? or should I move it?

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

just watch the EGT tube, its hard to see when you got the wire in there between the battery and teh engine but if it touches it it'll melt and bouce around on the tube giving you these trippy readigs. Route the wire around teh battery or something. It sure looks like it'l be better if you just went straight to the manifold but you should go around the battery just to be safe...

about the apexi does it have a peak hold function where the light goes off at a set temp? I think those are great cuz when your racing you tend to not pay attention to the gauges and if looking at a light helps you decipher that you engine is running to fast in X second faster than looking at numbers with a needle it's worth it. I love my autometer though ^_^

http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr
Who sez FF can't drift?

yeh, all the apexi guages have those settings and stuff as far as i know. i can acutally get the apexi egt for 240 if anyone's interested. thats the one i'm getting in about a month or so. ps i just checked my compression and it's better than last time, lol. i didnt' think that was possible. of course i've been at 3psi for the last month and a half, that mite have something to do w/ it.

-bryan
'98 rst