will i be tapping into the ecu directly under the hood, or is there a place to tap it inside the car? also i know the downstream 02 sensor has wires in the interior can i tap into those or should i be tapping into the upstream o2
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
#19782, "RE: about a/f guage where did you tap into" In response to Reply # 1
exactly what I was going to type
yep I tapped into the ecu in the engine bay. Just run it through the steering boot and get one of those claw grabber thingies that you use to take spark plugs out and a flashlight and fish that thing out. Have fun ^_^ all these darn gauges it's hard watching the road and the gauges at the same time
http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr Who sez FF can't drift?
#19783, "RE: about a/f guage where did you tap into" In response to Reply # 2
If you're asking about the wire, ti's on the top plug of the ECU, white wire w/ black stripe. I just did mine last night, VERY easy install! Good luck!
Jeremy
96 Indy Red Dodge Avenger I4 5spd 225.7whp/227.2wtq @ 10psi, currently running 12-14psi. HRC Stage III turbo setup JE 8.8:1 pistons Eagle rods block bored .020" over GReddy FMIC w/ custom piping 1G crushed BOV SPEC Stage 3 clutch 2.5" DP, 2.5" high flow cat, 3" ERT catback w/ Magnaflow muffler and 3" tip. much much more...
#19784, "RE: about a/f guage where did you tap into" In response to Reply # 3
ok i tapped into the only white wire near the pin location that my electric manuel indacated (sp?) and i'm getting voltage readings anywhere from .25 to .45 is this right could i have mabye tapped into the wrong wire. i'm worried because my manuel had 2 circut diagrams and it was saying 2 different pins for the same wire one chart said 48 one said 47 but there was only one wire from like 45-50 on the pins the rest were empty tia guy's i'm lost on this one..... the tt part works great though
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
#19786, "RE: about a/f guage where did you tap into" In response to Reply # 5
well that would be cool but i already tapped it on the white wire with no stripe do the readings that i'm getting sound correct? what voltage readings should i be looking for to tell me lean or rich conditions are present
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
Search
Printer-friendly copy
1 User in Chat
