I am in the process of installing my turbo and need to know if anyone knows what was use dto remove the oil pressure sending unit bolt...what size socket? tia
#19223, "RE: oil pressure sending unit" In response to Reply # 2
ok well we tried a 1 1/16 " deep well socket and it was too big...so we bought a 24 mm socket and a 1" and none of them worked either...i am calling Hahn tomorrow to see whats up with that...ill post to let people know...
about the downpipe...we didnt disconnect it from the cat con...we took it off the bracket and pulled it down as far as we could and made the cut 2.5" up from where it states in the directions...we were through it with a hacksaw in about 10 minutes...had the arms movin as fast as they would go...hope that helps
#19224, "RE: oil pressure sending unit" In response to Reply # 3
dont worry its 1 1/16 i jes think you got one that was to short. that puppies long. i had to go to school and borrow one from my teacher. also when going to a shop tyo ask for the socket ask if they have any sensor sockets. thats what the socket he gave me was called. if the socket is close to being as long as a credit card then it should fit. well good luck getting the downpipe off. airtools help alot!!!! l8r
"Proud to be, a 2gnt"
-mitsuman
Turbo: 1. HRC STG 2 2. Blits SS BOV 3. HKS Turbo timer
Exhaust: 1. Greddy Power Extreme
Ride: 1. Motegi MR7 17'' wrapped in yokohama A550v 235/45/17