I am in the process of installing my turbo and need to know if anyone knows what was use dto remove the oil pressure sending unit bolt...what size socket? tia

You will need a 1 1/16" deep well socket.

thanks for asking that, cuz I'm also in the process. I cannot get the downpipe off for shit. That mofo is rusted to the cat con.

ok well we tried a 1 1/16 " deep well socket and it was too big...so we bought a 24 mm socket and a 1" and none of them worked either...i am calling Hahn tomorrow to see whats up with that...ill post to let people know...

about the downpipe...we didnt disconnect it from the cat con...we took it off the bracket and pulled it down as far as we could and made the cut 2.5" up from where it states in the directions...we were through it with a hacksaw in about 10 minutes...had the arms movin as fast as they would go...hope that helps

dont worry its 1 1/16 i jes think you got one that was to short. that puppies long. i had to go to school and borrow one from my teacher. also when going to a shop tyo ask for the socket ask if they have any sensor sockets. thats what the socket he gave me was called. if the socket is close to being as long as a credit card then it should fit. well good luck getting the downpipe off. airtools help alot!!!! l8r


"Proud to be, a 2gnt"


-mitsuman

Turbo:
1. HRC STG 2
2. Blits SS BOV
3. HKS Turbo timer

Exhaust:
1. Greddy Power Extreme

Ride:
1. Motegi MR7 17'' wrapped
in yokohama A550v
235/45/17

Sound:
1. sony xplod cdxm620 deck
2. 2 10'' audiobahn subs
3. nice shiny audiobahn
amp

In room:
1. blitz front end(thnx 2
eclipse804)
2. H&R sport springs(thnx 2
eclipse804)

Fun mods:
1. "Nozzel mod"

Wanted:
1. to much ish to list

SOc07, you da man, that's exactly what I'm gonna do......with the rotozip!