Hey guys,
I've read a couple of messages that mentioned cutting of the downpipe being required to install the HRC. I want to install mine in my garage but I don't have any tools to cut the pipe. Is it a pain in the ass, or a no-brainer? Suggestions?

Thanks,

Corey,
98 RS

Go get a hacksaw with a nice cutting edge made for metal. They cost less than $10. That's what I did. I'm sure you might be able to get some sort of attachment for a dremel tool as well.

But I just used a hacksaw, and went to town on it for about 10 minutes. Took some elbow grease and sweat...but the end result is worth it.

Jason
98' Eagle Talon ESi-T
Mitsu Super 16g Turbo(HRC)/Custom FMIC

http://springfielddsm.homestead.com/JasonsPics.html

_____________________________________
Jason ESi-T

04' BMW 325Ci
91' Nissan 240SX
98' Eagle Talon ESi (sold)

Thanks,

I was thinking along those lines, but I didn't know how perfect of a cut it needed to be.

even easier- use a jigsaw with a metal cutting blade.. takes about a minute.

2GNT Member #76, since Fall 1999

Drives: 2004 Mazda RX-8
Drove: 1999 Saab 9-5 SE
1999 Eclipse GS Hahn Stage 1

Cut the exhaust pipe on my Neon with a Sawsall done in a minute.

"The fastest draw is when the sword never leaves the scabbard,
The strongest way to block, is never to provoke a blow,
And the cleanest cut is the one withheld."

Michael J. Kulaga e-mail: Michael_97RS@2gntDSM.zzn.com
aol IM: MJKulga Website: http://highlander.dsmpower.com/

All Motor Beast in the Making

Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors and Carbon Fiber Pads

To Be Installed: Rear disc brake conversion kit, SS Brake Lines, Rear KVR Cross Drilled Rotors and KVR Carbon Fiber Kevlar Pads

Firefly:
Mal: You don't know me, son, so let me put this to you plainly: If I ever kill you, you'll be awake. You'll be facing me. And you'll be armed.

I cut mine with a hacksaw and when the damn downpipe was still attached to the cat. hehe It was very painful on my arm but only took like 10 mins. Just make sure you shave down all that filing after its cut.

Robert Parkhurst
toykilla@comcast.net