i just bought a widband a/f guage was wondering what sensor i needed just bought gauge not the full setup.
thanks for any help

Do you have the gauge integrated contorller (30-4100)? or just the display (gauge) that is an add on to a controller?
if its just the add on gauge then you either need UEGO controller 30-2300 & 30-2301 for the display to work.
as for the sensor for both options, its a bosch sensor that you can order from AEM the part number for a replacement UEGO sensor is 30-2001
or get it from Jegs (#017-30-2001) its $67

______________________________________
______________________________________
"Don't fear the weapon, fear the soul of the warrior using it."
"My CEL only goes off when i remove my battery."

Best sum up of working on a 2GNT
DR1665- "#5. Spike that motherfucker on the garage floor and grab a beer. You deserve it."


Ahhhh Priceless . . .
eclipse982nrRST "its actually lightish red"
RoninEclipse2G "yeah, they already have a color for that... it's called PINK"

mine has some laser-etched serial chip thing in the connector that has to match up, not sure again if you have a simple gauge or the controller. I have the controller type, and am curious about how i'll change the sensor when it goes out. probably just a wire-in will be needed.

/>

'95 GS w/ t3/t4b
FMIC, diy piping & RFL BOV
MS2-Extra Fuel&Spark
50 lb/hr Holley injectors w/ 1:1 RRFPR
JE 8.8:1 dish w/ Hastings Rings
Eagle Rods w/ ARP bolts
ARP Head studs
Mild port/polish head
3" custom DP/cat section, 3" PIT catback
dual MBC - 12 psi / 20psi

I got the one that goes with the uego controller before and for some odd reason(probably with my wiring)it fried the controller. The one that is used with the controller doesn't have any harnesses that can be plugged into the back of the gauge, it just have a harness already built into the back of the gauge. I got the 6-1 AEM wideband now and I love it. I think the cheapest I found the bosch sensor was at cardomain, but not sure.

- 98 Eclipse rs turbo