I have spoiler holes from where my old spoiler was but all the body shops said they dont want to weld them close because the metal is to thin and it will warp it. I dont want to just glob bondo in there because it will end up cracking through the paint. What did you guys do to get rid of the old holes?

Shawn
99 Eclipse RS
Hahn Stage 2,Full built bottom end with je 8:8 and eagle rods ect..

weld . use a wet rag and it wont warp .

LED tails : Done for now!
99 eclipse rst
cobalt blue met. paint,star stage 2 upgraded t3/t460trim turbo ceramic coated , polished compressor housing, ,optima yellow top, chrome i/c piping ,front mount ntercooler ,apexi turbo timer . zeitronix wb02 ,faze oil ,boost gauge,egt ,bosch 4x plugs,kyb agx struts, pro kit springs.17''adr venomous rims,Falken azenis ,brembo dilled/slotted rotors ,turbo xs bov ,oil catch can,manual shiftknob,autometer pyrometer egt , vortech sfmu,b&m fuel pressure gauge ,accel 310cc injectors ,gasketmatched and polished intake manifold ,58mm throttle body ,no egr,polished turbonetics wastegate,fuel pump rewire,homade fcd and a lot more .LED reverse lights ,sidemarkers and tails .atx to mtx swap . South bend tz clutch . Tons more
http://imageshack.us>


http://www.2gnt.com/index.php?d=boosted60trimrst
My contribution to the wiki
http://www.2gnt.com/index.php?d=crank%20arm%20spindle%20mod%20to%20fit%20power%20panels

mine were welded shut

-------------------------------


1997 Dodge Avenger - 13.7 @ 105

Most people weld it with no probs. If it does warp slightly, a thin layer of bondo will fix all that...

BTW, does anyone know the easiest way to fill spoiler holes on a car you don't care about? They just need to be closed to keep water out because the spoiler is cracked. You think some jb weld would do it? Actually, I think I may have answered my own question. I filled holes in the spare tire well (from drilling out the spare tire bracket) using cold weld (along with masking tape underneath it), and it's held up fine...

________________________________________

2004 WRX - WR Blue Pearl
1997 Eclipse GS - Royal Sapphire Pearl

weld it just make sure to keep the metal as cool as possable, i did a little bit on one hole then moved to another hole and i kept a bucket of water that i kept puting on the metal around it too keep it cold, then u will need a thin coat of bondo or putty ontop

97 wide body with 1g turbo setup

dont weld atall, put some plastic matting underneath the hole and fiberglass it in with durglass fiberglas filler, or bondo, bond over the top, sand till smooth??? thats what idid

________________________________________

2004 WRX - WR Blue Pearl
1997 Eclipse GS - Royal Sapphire Pearl

just have it welded up man if they know what they are doing it won't be a problem.

_______________________

-eric stratton
Kustom Auto Koatings
North East, Md
443-528-8007
http://www.kustomautokoatings.com

Yea definitely get it welded. If you use fiberglass and bondo it will eventually shrink and you will see the imperfections. Do it right the first time so you won't be kicking yourself in the ass later.

www.Project2G.com

I just wish my car was as fast as it was loud. people tell me i should use my sub to push it, it might go faster.